• Support
• Overview
• Announcements
• Technical Support
• Login Here
• User Guide
• Technical Links
• Technical FAQ
• Partners

DVB receiver Installation and Configuration.

(KiSS SATDEM)

General settings

• Make sure the computer is totally Turn-off before installing the DVB Receiver card.
• Install the DVB Receiver card on the available PCI slot of your computer and follow the instructions written on each DVB Receiver User¡¦s Manual. (Included in the box)
• Make sure that DVB Receiver adapter do not have any IRQ conflict with the other network adapter. Check Start, Settings, Control Panel, System and go to Device Manager and click the Network Adapter

Satellite Receiver Card Settings

1. Go to Start, Programs and KiSS SATDEM.
2. Then click KiSS SATDEM Tuner.
3. Set the KiSS SATDEM Tuner Control parameters as shown below.
   
4. Add the same Frequency setting, Symbol
5. Rate setting and the Polarization setting.
6. Then click O.K. and it should make the Signal O.K. locked.
7. Then add the PID's (Note: To set the PID to Unicast, highlight the Mac Addr Filtering)
8. Then click to minimize and you are done.

Back to User Guide listing.